Enrolling your fingerprint is a one-time setup that gives you secure and seamless access to your digital vault. Since Byteseal is a Bluetooth-connected biometric device, the fingerprint enrolment process is slightly different from what you're used to on smartphones. It requires a bit more attention, timing, and patience — but it ensures top-notch security for your data.

🔍 Important Note Before You Begin

Unlike smartphone fingerprint sensors, Byteseal operates via a wireless connection and is optimized for accuracy over speed. The enrolment is designed to capture your fingerprint in multiple stages, ensuring the best match during authentication.

Please make sure:

• You are in a stable Bluetooth range.

• Your finger is clean and dry.

• You follow the LED cues carefully.

Here is a quick video describing the process properly.

🛠️ Step-by-Step Enrolment Process

1. Navigate to Fingerprint Enrolment

• Open the Byteseal app or software.

• Go to:
  Manage Byteseal Biometric ID > Connect Device > Select Fingerprint to Enroll > Start Enrolment

2. Observe the Blue LED

• Once you start enrolment, a Blue LED on your device will turn on.

• This means the device is ready to capture your fingerprint.

3. Place Finger on Sensor (Timing is Key)

• Wait for 2 seconds after the Blue LED turns ON.

• Then gently place your selected finger on the fingerprint sensor.

4. Watch for the LED to Turn Off

• As soon as the device reads your fingerprint, the Blue LED will switch off immediately.

• Remove your finger after the LED turns off.

5. Repeat the Process – Total 5 Times

• The LED will light up again after a short delay.

• Each time the LED lights up:

  • Wait 2 seconds.

  • Place the same finger again.

  • Remove after the LED switches off.

🔁 Repeat this cycle a total of 5 times to complete the enrolment process.

✅ Tips for Successful Enrolment

• Be patient. Don’t rush between LED cues.

• Use consistent finger pressure – not too hard, not too light.

• Avoid moving your finger while it’s on the sensor.

• Try to vary the angle slightly each time so that different parts of your fingerprint are captured.

🎉 Once Completed

• You will see a confirmation on the app indicating successful enrolment.

• You can now use this fingerprint for secure access and autofill with Byteseal.

If the process fails, don’t worry — just start over. Most issues are resolved by:

• Ensuring the device is properly charged and connected.

• Keeping your hand still and following LED cues accurately.